Ignition Upgrade Module for 2004-up Carbureted Harley Davidson Motorcycles...
download 1. Disconnect the negative battery cable. 2. Grasp the sides of the electrical caddy (located next the ignition coil) and pull outward to remove. 3. Remove the relay and fuse panels from the...
View ArticleHonda CR 125/ 250R The MSD Enhancer Ignition INSTALLATION
download The following explains some technical aspects of the Enhancer Ignition. Battery: The battery is necessary to the operation of the Enhancer in two regards. • The battery supplies voltage to the...
View Article4-STROKE TRIUMPH SINGLE CYLINDER MOTORCYCLES ELECTRONIC IGNITION SYSTEM...
download 1. Remove the petrol tank (and seat if necessary) to gain access to the ignition coil, condensor and wiring. 2. For safety, disconnect the battery, if fitted (preferably both terminals). 3....
View ArticleULTIMA IGNITION MODULE AND KIT INSTALLATION MANUAL FOR HARLEY DAVIDSON
download Disconnect battery. 2. Mark location of timing plate in relation to inside of cam cover. This will give a starting point for timing on new module. Remove old ignition if applicable (see...
View ArticleTRIUMPH TWIN CYLINDER MOTORCYCLES WITH POINTS IN THE SIDE CASING INSTALLATION...
download 1. All connections must be of the highest quality, use crimped or soldered connections; twisted wires will not give a satisfactory operation. 2. Remove the petrol tank and/or seat to gain...
View ArticleNORTON TWIN CYLINDER MOTORCYCLES ELECTRONIC IGNITION SYSTEM INSTALLATION...
download 1. All connections must be of the highest quality, use crimped or soldered connections; twisted wires will not give a satisfactory operation. 2. Remove the petrol tank and/or seat to gain...
View ArticleNORTON LIGHTWEIGHT TWIN ELECTRONIC IGNITION Installation Instructions
download 1. All connections must be of the highest quality, use crimped or soldered connections; twisted wires will not give a satisfactory operation. 2. Remove the petrol tank and/or seat to gain...
View ArticleHI-4 DUAL FIRE MOTORCYCLE IGNITION INSTALLATION INSTRUCTIONS
download Turn ignition switch off and disconnect battery ground cable. 2. Refer to Figure 3. Remove OE ignition module and wire harness (items 1-4). You will disconnect two wires at the coil (15), a...
View ArticleKawasaki Sxi/ SXR Ignition twin cylinder Jet Ski ignition Installation...
download 1. Remove electronics enclosure from its mounting location. 2. Unplug and remove the OEM ignition. 3. Set the programming switches on the T3 to your settings. 4. Install the T3 Ignition in the...
View ArticleHarley-Davidson Electronic Ignition Module Installation instructions
download Step 1: Switch main dashboard switch to “off” position (Ignition& light switch) Step 2: Disconnect negative (ground) cable from the Battery Step 3: Remove the Condenser and Breaker points...
View Article
More Pages to Explore .....